Read the Progressive Dairy Canada digital edition
advertisement

How to make breeding day more effective - Part 2: Improve semen handling

Anibal Ballarotti for Progressive Dairy Published on 02 March 2021

Before breeding, check that all necessary equipment and supplies for handling semen are ready. Identify potential problems before starting, as errors and fixes can waste time and compromise fertility.

The key here is to minimize the time semen is exposed to temperature oscillations and direct sunlight and to prevent contamination with water, manure or detergents.

advertisement

advertisement

thermometer

1. Ensure proper thawing temperature before pulling the frozen straw from the tank (35-37°C, as checked with a digital thermometer).

Stop watch

2. Thaw the semen straw in the water bath for at least 30 seconds.

list

advertisement

3. Keep an organized semen inventory that allows the semen unit to be located within 5-10 seconds.

tweezers

4. Tweezers should be used to remove semen from the tank, taking care to maintain the canister below the frost line. If the straw is not located within 10 seconds, the canister should be lowered back into the nitrogen for at least 10 seconds before recommencing identification.

straws

5. Thaw a maximum of five straws at a time (or less if the breeder is not able to place those 5 straws in the cows within 10 minutes for sexed semen, or in 15 minutes for conventional semen).

6. The actual number of units to thaw should be based on the technician’s efficiency and facility impacts (travel distance, pen size, lockups, pass-throughs).

advertisement

scissors7. Straws should be properly dried after removal from the thaw unit and protected from sunlight. Cut straws straight across, not at an angle, at the crimped, sealed end and snap into the adaptor of the plastic sheath to prevent semen passing back into the A.I. gun.

Papertowels8. Always keep clean paper towels on hand to remove manure.

9. Open the vaginal lips to avoid touching the gun on anything that could contaminate it.

Timer

10. Depress the plunger on the A.I. gun with a slow, gentle motion and complete the task in no less than 5 seconds. end mark

ILLUSTRATION: Illustrations by Kristen Phillips.

This article is part of a series. Click here to read the other articles: "How to make breeding day more effective – Part 1: Nitrogen tank and equipment maintenance" and "How to make breeding day more effective – Part 3: Set reasonable expectations for your breeder"

Anibal Ballarotti
  • Anibal Ballarotti

  • Consultant
  • ABS Global Inc
  • Email Anibal Ballarotti

LATEST BLOG

LATEST NEWS